Opening your workspace…
We couldn’t reach your workspace.
Check your connection, then try again.
YOUR PRIVATE WORKSPACE
Everything connected.
Nothing in the way.
Set up the Mac that runs Claude Code, pair your Rokid Glasses, and keep every connection in view.
- Your code stays on your MacThe cloud carries session traffic; it does not run your agent.
- No password to rememberWe send a private, single-use sign-in link to your inbox.
- One place for every deviceSee your relay and revoke paired devices whenever you need to.
Create your account or sign in.
Enter your email to receive a private link. New here? Verifying your email creates your account. Already registered? The same link signs you in.
Already have an account? Sign in
- Verify your email using the single-use link, valid for 15 minutes.
- Open your account. If your licence is active, go straight to app setup; otherwise, arrange activation with our team.
No password. No repository upload. You stay in control.
See our terms and privacy notice. Creating an account does not start a paid subscription.
SERVICE ACCESS
Your licence is awaiting activation.
Your account is ready. Service access starts after your licence is activated.
Request manual activation. We’ll email your verified account address to godefroy@codecrush.asia so the team can review your request and reply to you.
Your account is created. App setup unlocks after manual licence activation; this request does not start a paid subscription.
SETUP CONTROL
Connect your setup.
Three small steps between your Mac and a hands-free Claude Code session.
Manage licences →THE ENGINE
Your Mac
Checking the relay…
Claude Code and your repositories stay here. Keep this Mac awake and online while you use the glasses.
1 · INSTALL COMMAND
It holds no secret.
2 · RELAY KEY
Shown once. The install command asks for it: paste it there. It is not displayed, and it replaces any key this Mac saved before.
Paste the command in Terminal on your Mac, then the key when it asks, and come back to this page: it updates as soon as your Mac connects. The relay installs in ~/rokid-relay and needs Node.js and Claude Code. Voice input also needs about 500 MB of disk space for a speech model, downloaded on first start after asking. Next time, run ~/rokid-relay/start.
YOUR MACS
No Mac connected yet.
YOUR CONNECTIONS
Paired devices
Pair from your Mac. On the Mac that runs the relay, open http://127.0.0.1:8787/pair/ — ~/rokid-relay/start prints the same address. It shows the code for your glasses or phone and adds an end-to-end key that never reaches this site. Paired devices appear below, where you can revoke them.
Start with your Rokid Glasses, or add the phone companion.
READY TO SCAN
Pair your device.
This code is shown once. If you close it before scanning, create a new one.